Charming, Chic and Commanding Construction and Contracting Concepts

DIY Steps to Repair Drooping or Sagging Ceiling Tiles

The problem of drooping or sagging ceiling tiles is often experienced in older buildings. Also, wrong selection of tiles, high humidity, and high temperatures can be blamed for causing sagging in ceiling tiles. Drooping tiles are not only an eyesore to a home, but they can also hurt someone if they fall. It is essential to have them repaired immediately to avoid associated hazards. If you are a handy DIYer, then this is a task that's worth undertaking with a few simple tools and techniques. Here are some steps that you can follow.

Identify the problem

Before beginning the repair process, it is essential to determine the cause of the drooping. If it is due to high temperatures, consider adjusting your HVAC system temperature to a lower range. Humidity problems can be caused by water leaks from a faulty plumbing system. In such a case, repairing the tiles alone will not fix the problem. Ensure you take care of the plumbing issue to avoid future tile repairs.

Remove loose tiles

After identifying and fixing the problem causing the tiles to sag, determine the extent of the damage to your ceiling tiles. Remove all the loose tiles, and do this carefully without disturbing the tiles that are properly fixed. Since most ceiling tiles are usually placed using an adhesive and staples, you can use a putty knife to loosen and remove them without breaking them.

Apply adhesive and staple the tiles

Plastered tiles are usually attached to the ceiling using a glue product only; however, tiles are stapled to furring strips on the ceiling for proper attachment. For this step, you will need your putty knife, adhesion material, a staple gun, and staples. Apply the adhesive to the inner side of the tile and place the tile on its furring strip. The two will attach due to the adhesion material. Load the staple gun with staples and staple the tile onto the furring.

Repair all the tiles

Apply adhesion on all the removed tiles, fix them on their furring strips, and staple them. As you place the tiles back, ensure you lay each of them on its furring strip for uniformity. Once you finish, inspect the ceiling around the repaired area to make sure that there are no disturbances that may have caused other tiles to loosen as well.

Repairing ceiling tiles can be an easy DIY job; however, sometimes, the damage may be too extensive for the average DIYer to handle. Also, if there is any water damage to your tiles, you may need to have them replaced. Consider contacting a ceiling repair contractor to fix the root of the problem and repair or replace your ceiling tiles.